600px.jpg.jpg)
The Everhot Electric Heater
Plugs in to an ordinary 13amp socket.
Doesn't need a chimney, and you don't need to carry all the wood or coal in from outside.
Steel and cast-iron construction retains heat even after it's been switched off.
1.5kW heating element with thermostatic control.
Note: This is the lower-spec version with no oven!
If you'd prefer a working oven then see the Everhot Electric Stove information.
Easy Installation
There's no complicated flue or hearth to worry about - just put it in position and plug it in.
Simple to Control
Set the thermostat dial to the desired heat output and that's it.
Colour Options
Available in lots of colours either to match your Everhot Cooker or to tone in with the room's décor.
(Also available in the Heater and Stove-only colour of Matt Black.)

250px.jpg)
Heat Output
Maximum: 1.5kW
Minimum: 0.3kW
(Power cord length: 1.5m)
Installation Requirements
Not recommended to be installed on deep or thick-pile carpets.
Better on thin-pile carpets or ideally a non-combustible or fire-resistant hard surface. (A hearth isn't required.)
The majority of the heat is emitted through the heat-vent on the top of the stove - do not locate immediately below a counter, table or near curtains.

Thermostatic control for the 1.5kW element.

Electric Supply
One 13amp socket outlet.
Weight
Approx. 40kg
Clearances Required
Above - 300mm.
Behind - 100mm
To the sides - 150mm.

